THE THX-6000-LCR IS A THX® ULTRA2 CERTIFIED LOUDSPEAKER

It was designed primarily for front left-, center-, and right-channel reproduction in large, ultimate-performance home theaters. It can also be used for surround channels, however, and is equally suitable for combination home-theater/music systems demanding superb sound and high output capability. Its enclosure is front-ported to facilitate installation in custom cabinetry and has back – panel 1/4” – 20 threaded inserts compatible with the Klipsch SB-9 mounting bracket or any high quality wall/ceiling speaker mount rated for 40lbs or higher load.

THE THX-6000-LCR DESIGN EMERGES DIRECTLY FROM KLIPSCH’S EXPERIENCE AS A LEADING SUPPLIER OF CINEMA SOUND SYSTEMS

A large, rectangular 90° x 60° Tractrix® Horn raises the efficiency of the speaker’s 1-inch titanium-dome compression driver tweeter and optimizes its radiation pattern. The horn enables the speaker to meet THX Ultra2 directivity specifications without the lobbing and comb filtering effects that afflict conventional multiple-tweeter solutions. And its dual 6.5” woofers have large, magnetically shielded motor structures that drive rigid, low-mass Cerametallic™ anodized-aluminum vcones for high output and low distortion.

FREQUENCY RESPONSE:48Hz - 20kHz ± 3dB

SENSITIVITY:97dB @ 2.83 volts / 1 Meter

NOMINAL IMPEDANCE:8 ohms compatible

HF CROSSOVER:1400Hz

POWER HANDLING:150 watts maximum continuous (600 watts peak)

ENCLOSURE TYPE:Bass Reflex via front-mounted port

ENCLOSURE MATERIAL:Medium density fibreboard construction (MDF)

TWEETER:1” (2.5cm) magnetically shielded, titanium dome compression driver with 9.6oz ceramic magnet structure.

HIGH FREQUENCY HORN:10” x 6” rectangular 90° x 60° Tractix® Horn

WOOFER:Two 6.5” (16.5cm) magnetically shielded, Cerametallic™ cone, cast aluminium frame drivers

INPUT CONNECTIONS:Two sets of binding post speaker terminals (connected via brass strap jumpers)

DIMENSIONS:15” (38.1cm) H x 17” (43.2cm) W x 12.5” (31.8cm) D (w/grille)

WEIGHT:39 lbs. (17.7kg)

MOUNTING:4-Bolt pattern 1/4” - 20 thread